Sealcoat is applied to driveways and other pathways to avoid penetration of harmful substances into the asphalt that is used in construction. It also gives it a cleaner and more aesthetically pleasing appearance. It is a liquid that is applied on top of a driveway or other related areas to act as a protective mechanism against harsh conditions. In the case of parking lots, after the seal coating is done, it is striped or restriped to obtain the desired layout. Parking Lot Sealcoating and Striping Central Alabama is essential for your parking space.
With damages caused by degradation resulting from elements like oil, water, friction and UV light, repairs may be generally very costly. This warrants the application of seal coats to prevent cracks, loss of appeal and brittleness. Sealcoats are usually of bituminous or acrylics content. Asphalt is commonly used to glue the materials used in construction to help in binding the components although it is usually susceptible to damages hence the need for a sealer.
There are different types of sealers which are of different qualities. They include the refined tar-based sealer, the asphalt-based sealer, the petroleum-based sealers among others. The refined tar-based sealer has been primarily used as it offers the best protection. It is highly water and chemical resistant in comparison to the other two mentioned. The asphalt-based sealer is also good water and chemical repellent. Unless otherwise stated, one can use a sealer of their preference.
The process ought to be carried out after an area to be worked on is cleaned and left to dry completely. Dirty surfaces are avoided to prevent poor adhesion. The process utilizes two coats hence two days will be sufficient and which should be in the warm seasons to avoid the rain. Ideally, the seal coat can be applied by spraying an area of about sixty square feet for every gallon of the coat.
It is important to note that the coat takes about 24 hours to dry and, therefore, no car should be allowed in the area during this time. Sealcoats can be reapplied every two to three years as is the given standard or depending on the deterioration of the parking lot. This will continue to extend the life of the surface for over 12 years or more without needing repairs.
Since they are professionals not only in applying sealcoats but also to stripe the pavement, they will be able to stripe or restripe the surface as preferred. This is usually done after the sealcoat is applied and has dried. It gives the lot an aesthetically pleasing effect and also maintains the safety of the cars.
The preferable paint to use is acrylic waterborne paint which is applied at a very high temperature. Rather than applying a thick coat of the paint, good appeals require thin layers. Restriping may possibly be carried out after two years and also when the painting fades up to less than 75% of the original color.
The process of undertaking such activities to the driveways can be very expensive depending on the materials that are being used. Its, however, beneficial in the long run as future cost of repairs are avoided and is recommended by contractors.
With damages caused by degradation resulting from elements like oil, water, friction and UV light, repairs may be generally very costly. This warrants the application of seal coats to prevent cracks, loss of appeal and brittleness. Sealcoats are usually of bituminous or acrylics content. Asphalt is commonly used to glue the materials used in construction to help in binding the components although it is usually susceptible to damages hence the need for a sealer.
There are different types of sealers which are of different qualities. They include the refined tar-based sealer, the asphalt-based sealer, the petroleum-based sealers among others. The refined tar-based sealer has been primarily used as it offers the best protection. It is highly water and chemical resistant in comparison to the other two mentioned. The asphalt-based sealer is also good water and chemical repellent. Unless otherwise stated, one can use a sealer of their preference.
The process ought to be carried out after an area to be worked on is cleaned and left to dry completely. Dirty surfaces are avoided to prevent poor adhesion. The process utilizes two coats hence two days will be sufficient and which should be in the warm seasons to avoid the rain. Ideally, the seal coat can be applied by spraying an area of about sixty square feet for every gallon of the coat.
It is important to note that the coat takes about 24 hours to dry and, therefore, no car should be allowed in the area during this time. Sealcoats can be reapplied every two to three years as is the given standard or depending on the deterioration of the parking lot. This will continue to extend the life of the surface for over 12 years or more without needing repairs.
Since they are professionals not only in applying sealcoats but also to stripe the pavement, they will be able to stripe or restripe the surface as preferred. This is usually done after the sealcoat is applied and has dried. It gives the lot an aesthetically pleasing effect and also maintains the safety of the cars.
The preferable paint to use is acrylic waterborne paint which is applied at a very high temperature. Rather than applying a thick coat of the paint, good appeals require thin layers. Restriping may possibly be carried out after two years and also when the painting fades up to less than 75% of the original color.
The process of undertaking such activities to the driveways can be very expensive depending on the materials that are being used. Its, however, beneficial in the long run as future cost of repairs are avoided and is recommended by contractors.
About the Author:
You can find a list of the advantages you get when you use professional parking lot sealcoating and striping central Alabama services at http://www.cofieldllc.com right now.